Ford Explorer: Second Row Seats / Description and Operation - Second Row Seats - Overview

Ford Explorer 2020-2026 Service Manual / Body and Paint / Body and Paint / Second Row Seats / Description and Operation - Second Row Seats - Overview

Overview

Heated Seats

If equipped with the heated seat system, the rear seat cushion and backrest can be heated at one of two levels on demand.

The components of the rear heated seat system include:

  • Seat cushion heater mat (LH/ RH)
  • Seat backrest heater mat (LH/ RH)
  • Heated seat module (attached to the underside of the RH second row seat cushion frame)
  • Heated seat switches (part of the RHVAC module located in the rear panel of the front floor console)

Heated/Ventilated Seats

If equipped with the heated/ventilated seat system, the heated/ventilated seat control buttons and indicators are located on the RHVAC module. Each time the heated/ventilated seat buttons are pressed, the RHVAC module output and LEDs (light emitting diodes) decrease one setting. The sequence is:

  • High - all 3 LEDs (light emitting diodes) illuminated
  • Medium - 2 LEDs (light emitting diodes) illuminated
  • Low - 1 LED illuminated
  • Off - no LEDs (light emitting diodes) illuminated

The heated/ventilated seat system consists of the following components:

  • Heated/ventilated seat control switches (part of the RHVAC module located in the rear panel of the front floor console)
  • Seat cushion heater mat (LH/ RH)
  • Seat backrest heater mat (LH/ RH)
  • SCMF (attached to the underside of the RH second row seat cushion frame)
  • Cushion and backrest vent bags (part of the cushion and backrest foam)
  • Air duct (bellow)
  • Cushion and backrest foam
  • Cushion and backrest trim covers

Power-Fold Down Backrest

If equipped with the power-fold down backrest, pressing and releasing the LH or RH easy entry seat fold switch (located on top of the seat backrest) allows the corresponding rear seat backrest to fold forward for access to the third row seats.

The power-fold down backrest system consists of the following components:

  • Second row single seat easy entry seat fold switch(es) (located on top of the outer edge of the backrest cushion)
  • Second row easy entry power release cable
  • Second row easy entry power release actuator
  • SCMJ (located under the LH second row seat cushion)

    Second Row Seats

    ..

    Description and Operation - Second Row Seats - System Operation and Component Description

    System Operation System Diagram - Heated/Ventilated Seats Item Description 1 RHVAC 2 MS-CAN 3 SCMF 4 LH Second Row Seat 5 Cushion Tem..

    Other information:

    Ford Explorer 2020-2026 Service Manual: Description and Operation - Parking Brake - Overview


    Overview The parking brake system uses 2 switch activated, Electronic Control Unit (ECU) controlled motors to apply and release the rear brake calipers. The ABS module controls and monitors the parking brake system and sets Diagnostic Trouble Codes (DTCs) when a fault is present in the system...

    Ford Explorer 2020-2026 Service Manual: Removal and Installation - Transmission Internal Wiring Harness


    Special Tool(s) / General Equipment 307-625Fixture, Bench MountingTKIT-2008ET-FLMTKIT-2008ET-ROW 307-746Remover, Transmission Wiring Harness Connector Transmission Jack Vehicle/Axle Stands Wooden Block Materials Name Specification Motorcraft® MERCON® ULV Automatic Transmission FluidXT-12-QULV WSS-M2C949-A, MERCON® ULV  Removal NOTE: I..

    Categories

    Gauges

    4 Inch Display

    A - Tachometer.

    B - Information display.

    C - Speedometer.

    D - Fuel gauge.

    E - Engine coolant temperature gauge.

    read more

     
    Copyright © 2026 www.foexplorer.com