Ford Explorer: Power Liftgate / Stopping the Liftgate Movement
Note: Do not apply sudden excessive force to the liftgate while it is in
motion. This could damage the power liftgate and its components.
You can stop the liftgate movement by doing any of the following:
- Pressing the liftgate control button.
- Pressing the liftgate button on the remote control twice.
- Pressing the liftgate button on the instrument panel.
- Moving your foot under and away from the center rear bumper in a single-kick
motion.*
*This method only works for vehicles with the hands-free liftgate feature.
WARNING: Make sure all persons are clear of the power liftgate area before
using the power liftgate control.
Note: Make sure the area behind your vehicle is free from obstruction and
that there i..
Open the liftgate.
Stop the liftgate movement by pressing the control button on the liftgate
when it reaches the desired height.Note: Once the liftgate has stopped
moving, you can also manu..
Other information:
Removal
NOTE:
If installing a new PAM,
it is necessary to upload the module configuration information to the
scan tool prior to removing the module. This information must be
downloaded into the new PAM after installation.
Using a diagnostic scan tool, begin the PMI process for the PAM following the onscreen instructions...
Removal
NOTE:
If a heater core leak is suspected, the heater core must be leak tested before it is removed from the vehicle.
Remove the climate control housing.
Refer to: Climate Control Housing (412-00 Climate Control System - General Information, Removal and Installation)...
Categories
When these locks are set, you cannot open the rear doors from the inside.

A child safety lock is on the rear edge of each rear door. You must set the child
safety lock separately on each door.
Left-Hand Side
read more