Ford Explorer: Third Row Seats / Removal and Installation - Third Row Seat Backrest Cover

Ford Explorer 2020-2025 Service Manual / Body and Paint / Body and Paint / Third Row Seats / Removal and Installation - Third Row Seat Backrest Cover

Special Tool(s) / General Equipment

Flat-Bladed Screwdriver
Interior Trim Remover

Removal

NOTE: LH (left hand) shown, RH (right hand) similar.

  1. Remove the third row seat backrest.
    Refer to: Third Row Seat Backrest (501-10C Third Row Seats, Removal and Installation).

    1. Release the spring tension.
      Use the General Equipment: Flat-Bladed Screwdriver
    1. Remove the third row head restraint pad.
  1. Release the tabs and remove the manual head restraint release handle bezel.
  1. Detach the J-clip from the third row seat frame.
  1. Release the third row seat backrest cover J-clip.
  1. Release the tabs and remove the child safety seat tether anchor bezel.
    Use the General Equipment: Interior Trim Remover
  1. NOTICE: Use care when separating the backrest cover from the hook-and-loop strips or the hook-and-loop strips may be torn from the backrest foam.


    Remove the third row seat backrest cover.
    1. Roll the backrest cover up while detaching the hook-and-loop strips.
    1. Route the manual head restraint release strap through the backrest cover.

Installation

  1. To install, reverse the removal procedure.

    Removal and Installation - Third Row Seat Backrest

    Special Tool(s) / General Equipment Interior Trim Remover Removal   WARNING: The following procedure describes critical repair steps required for correct seat component installat..

    Removal and Installation - Third Row Seat Cushion

    Removal   WARNING: The following procedure describes critical repair steps required for correct seat component installation. Follow all notes and steps carefully...

    Other information:

    Ford Explorer 2020-2025 Owners Manual: Capacities and Specifications - 3.3L, Gasoline


    Use oil and fluid that meets the defined specification and viscosity grade. If you do not use oil and fluid that meets the defined specification and viscosity grade, it could result in: Component damage not covered by the vehicle warranty. Longer engine cranking periods...

    Ford Explorer 2020-2025 Service Manual: General Procedures - Cylinder Head Distortion


    Special Tool(s) / General Equipment Feeler Gauge Check NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: Make sure all cylinder head surfaces are clear of any gasket material, silicone sealant, oil and coolant...

    Categories

    Seatbelt Height Adjustment

    WARNING: Position the seatbelt height adjuster so that the seatbelt rests across the middle of your shoulder. Failure to adjust the seatbelt correctly could reduce its effectiveness and increase the risk of injury in a crash.

    read more

     
    Copyright © 2025 www.foexplorer.com