Ford Explorer: Third Row Seats / Removal and Installation - Power Fold Seat Control Switch
Special Tool(s) /
General Equipment
Removal
-
-
Depress the power fold seat control switch retaining clips.
Use the General Equipment: Interior Trim Remover
-
Depress the power fold seat control switch retaining clips.
Use the General Equipment: Interior Trim Remover
-
Position the power fold seat control switch out of the loadspace trim panel.
-
Disconnect the electrical connector and remove the power fold seat control switch.
Installation
-
To install, reverse the removal procedure.
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Informat..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
The SCMJ (power fold seat module) is located under the LH (left-hand) second row seat cushion frame...
Other information:
Switching the Front Fog Lamps On or Off
Only switch the front fog lamps on during reduced visibility.
You can switch the front fog lamps on if any of the following occur:
You set the lighting control to the parking lamps position.
You set the lighting control to the headlamps position...
WARNING: Do not put the shoulder section of the seatbelt or allow the child
to put the shoulder section of the seatbelt under their arm or behind their back.
Failure to follow this instruction could reduce the effectiveness of the seatbelt
and increase the risk of injury or death in a crash...
Categories
4 Inch Display

A - Tachometer.
B - Information display.
C - Speedometer.
D - Fuel gauge.
E - Engine coolant temperature gauge.
read more