Ford Explorer: Horn / Removal and Installation - Horn

Ford Explorer 2020-2026 Service Manual / Electrical / Instrumentation and Warning Systems / Horn / Removal and Installation - Horn

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the front bumper cover.
Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).

Disconnect the horn electrical connector.

Remove the bolt and the horn assembly.
Torque: 106 lb.in (12 Nm)

Installation

To install, reverse the removal procedure.

Diagnosis and Testing - Horn

Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Informati..

Parking Aid - Vehicles With: Rear Parking Aid

Other information:

Ford Explorer 2020-2026 Service Manual: Removal and Installation - Front Door Trim Panel

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: LH (left hand) shown, RH (right hand) similar. NOTE: Removal steps in this procedure may contain installation details. Remove the interior front door handle bolt cover...

Ford Explorer 2020-2026 Service Manual: Removal and Installation - Rear Parking Aid Sensor

Removal Remove the rear bumper cover. Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation). If equipped. Position aside the connector shields. Remove the rear parking aid sensor...