Ford Explorer: Evaporative Emissions - 2.3L EcoBoost (201kW/273PS) / Removal and Installation - Fuel Vapor Vent Valve
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
-
-
Remove the fasteners.
Torque:
53 lb.in (6 Nm)
-
Remove the fasteners.
-
Remove the fasteners.
Torque:
53 lb.in (6 Nm)
-
Remove the push pin.
-
Remove the fasteners.
Torque:
53 lb.in (6 Nm)
-
-
Disconnect the electrical connector.
-
Disconnect the quick connect couplings.
Refer to: Quick Release Coupling (310-00A Fuel System - General Information - 2.3L EcoBoost (201kW/273PS), General Procedures).
-
Remove the fuel vapor vent valve.
Installation
-
To install, reverse the removal procedure.
Special Tool(s) /
General Equipment
Transmission Jack
Removal
NOTE:
Removal steps in this procedure may contain installation steps.
Disconnect the battery...
Other information:
WARNING: Do not use the system in poor visibility, for example fog, heavy
rain, spray or snow.
Use the touchscreen to select the following:
Select Settings. See Settings.
Select Vehicle.
Select Lighting.
Activating the Automatic High Beam Control
Switch the lighting control to the
autolamps position...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove both the headlamps.
Refer to: Headlamp Assembly (417-01 Exterior Lighting, Removal and Installation).
Remove the Horn assembly.
Refer to: Horn (413-06 Horn, Removal and Installation)...
Categories
When these locks are set, you cannot open the rear doors from the inside.

A child safety lock is on the rear edge of each rear door. You must set the child
safety lock separately on each door.
Left-Hand Side
read more