Ford Explorer: Body Closures / Removal and Installation - Fuel Filler Door
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Open the fuel filler door.
-
Using a screwdriver, pry the retaining tab back and slide the fuel filler door from the fuel filler door hinge.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Open the door...
Special Tool(s) /
General Equipment
Flat Headed Screw Driver
Knife
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Open the door.
Remove the check arm bolt.
Torque:
18 lb.ft (25 Nm)
Disconnect the rear door electrical connector...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
This step is only necessary when installing a new component.
NOTE:
The PMI process must begin with the current RGTM installed. If the current RGTM
does not respond to the diagnostic scan tool, the tool may prompt for
As-Built Data as part of the repair...
Categories
Note: You may not be able to shift out of park (P) unless the intelligent
access key is inside your vehicle.

read more