Ford Explorer: Automatic Transmission - 10-Speed Automatic Transmission – 10R60 / General Procedures - Transmission Fluid Exchange

Ford Explorer 2020-2025 Service Manual / Powertrain / Automatic Transmission / Automatic Transmission - 10-Speed Automatic Transmission – 10R60 / General Procedures - Transmission Fluid Exchange

Special Tool(s) / General Equipment

Fluid Exchanger

Materials

Name Specification
Motorcraft® MERCON® ULV Automatic Transmission Fluid
XT-12-QULV
WSS-M2C949-A,
MERCON® ULV
 

Connect

NOTICE: Use transmission fluid specific for this transmission. Do not use any supplemental transmission fluid additives or cleaning agents. The use of these products can cause internal transmission components to fail, which will affect the operation of the transmission.

  1. With the vehicle in NEUTRAL, position it on a hoist.
    Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
  1. Connect the Fluid Exchanger to the transmission fluid cooler tube after the transmission fluid cooler on the return tube. This helps remove any foreign material trapped in the transmission fluid coolers.
    Use the General Equipment: Fluid Exchanger
  1. Perform the transmission fluid exchange using the Fluid Exchanger.
    • Follow the manufacturer's instructions included with the machine.
      Use the General Equipment: Fluid Exchanger
      Material: Motorcraft® MERCON® ULV Automatic Transmission Fluid / XT-12-QULV (WSS-M2C949-A, ) (MERCON® ULV)
    • Refer here for current material specs
        Material
  1. Once the transmission fluid exchange is completed, disconnect the Fluid Exchanger. Reconnect any disconnected transmission fluid cooler tubes.
    Use the General Equipment: Fluid Exchanger
  1. Check the transmission fluid level.
    Refer to: Transmission Fluid Level Check (307-01C Automatic Transmission - 10-Speed Automatic Transmission – 10R80 MHT, General Procedures).

    General Procedures - Transmission Fluid Drain and Refill

    Special Tool(s) / General Equipment 307-570Tube, Transmission FillTKIT-2006U-F/FMTKIT-2006U-FLM/LMTKIT-2006U-ROW1TKIT-2006U-ROW2 Fluid Suction Gun Universal Fluid Dispenser Materia..

    General Procedures - Transmission Fluid Level Check

    Check NOTICE: The vehicle should not be driven if the transmission fluid level is low. Internal failure could result. NOTE: If the vehicle has been operated for an extended period at high hi..

    Other information:

    Ford Explorer 2020-2025 Service Manual: Specifications


      General Specifications NOTE: Measurements listed at curb load. Curb load is defined as "full service fluids, full fuel tank(s), no passengers and no cargo". Item Specification Ball Joint Deflection Lower 0-0...

    Ford Explorer 2020-2025 Service Manual: Removal and Installation - Tire Pressure Monitoring System (TPMS) Sensor


    Removal   WARNING: The Tire Pressure Monitoring System (TPMS) sensor battery may release hazardous chemicals if exposed to extreme mechanical damage. If these chemicals contact the skin or eyes, flush immediately with water for a minimum of 15 minutes and get prompt medical attention...

    Categories

    Locking and Unlocking

    You can use the power door lock control or the remote control to lock and unlock your vehicle.

    Power Door Locks

    The power door lock control is on the driver and front passenger door panels.

    read more

     
    Copyright © 2025 www.foexplorer.com