Ford Explorer: Tire Pressure Monitoring System (TPMS) / Description and Operation - Tire Pressure Monitoring System (TPMS) - Overview
Overview
The BCM uses tire pressure sensors to monitor tire pressure. The sensors use radio signals to transmit the tire pressure to the RTM. The RTM sends the information to the BCM over a LIN.
The tire pressure sensors are battery operated and mounted to the valve stems.
The IPC illuminates the TPMS
warning indicator and the message center displays a message when a
fault is present or when the tire pressure falls below the low pressure
limit.
System Operation
System Diagram
E344777
*.sttxt {
visibility: hidden;
}
*.stcallout {
visibility: visible;
}
1
TPMS
Sensor
2
TPMS
Sensor
..
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
All vehicles
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module...
Removal
WARNING:
Disconnect the 12 volt battery before servicing the direct
current to alternating current (DC-AC) inverter or alternating current
(AC) powerpoint to prevent the risk of high voltage shock. Failure to
follow this instruction may result in serious personal injury...
Categories
When these locks are set, you cannot open the rear doors from the inside.

A child safety lock is on the rear edge of each rear door. You must set the child
safety lock separately on each door.
Left-Hand Side
read more