Ford Explorer: Automatic Transmission - 10-Speed Automatic Transmission – 10R60 / Description and Operation - Pump Assembly

Ford Explorer 2020-2026 Service Manual / Powertrain / Automatic Transmission / Automatic Transmission - 10-Speed Automatic Transmission – 10R60 / Description and Operation - Pump Assembly

Overview

Item	Description
1	Transmission fluid pump drive gear
2	Transmission fluid pump idler gear
3	Transmission fluid pump assembly
4	Transmission fluid filter

The transmission fluid in the sump area at the bottom of the transmission case flows through a transmission fluid filter to the pump assembly. The pump is bolted to the bottom of the case and is driven by a set of gears mounted on the stator support and turned by the torque converter.

Pump Assembly Exploded View

Item	Description
1	Transmission fluid pump driven gear outer cover
2	Transmission fluid pump driven gear
3	Transmission fluid pump driven gear inner cover
4	Transmission fluid pump
5	Transmission fluid pump idler gear
6	Transmission fluid pump idler gear bearing
7	Transmission fluid pump drive gear
8	Torque converter

Description and Operation - Main Control Valve Body

Item Description 1 Internal wiring harness retaining bolt 2 Internal wiring harness 3 Park lock pawl solenoid ..

Description and Operation - Planetary Assembly

Planetary Gearset Exploded View Item Description 1 Ring gear No. 1 2 Sun gear No...

Other information:

Ford Explorer 2020-2026 Service Manual: Description and Operation - Direct Current/Alternating Current (DC/AC) Inverter - System Operation and Component Description

System Diagram System Operation Network Message Chart Broadcast Message Originating Module Message Purpose Power pack torque status Secondary On-Board Diagnostic Control Module C (SOBDMC) Used to determine if the vehicle is started or if torque is available...

Ford Explorer 2020-2026 Service Manual: General Procedures - Module Programming

Check NOTE: Perform the following pre-checks to make sure module programming completes without errors. Start the programming session in KOEO. Make sure the vehicle battery is fully charged or is connected to a battery charger. The battery state of charge should be 12...