Ford Explorer: Lighting / Adaptive Headlamps (If Equipped)
The headlamp beams move in the same direction as the steering wheel. This provides
more visibility when driving around curves.
A. Without adaptive headlamps.
B. With adaptive headlamps.

The system only works with the lighting control in the autolamp position.
You can switch the system on or off in the touchscreen.
Note: There is a delay of two to five seconds before the system operates
when you drive your vehicle.
Note: The system is only active at speeds above 3 mph (5 km/h).
System Check (If Equipped)
The system has a power-up movement check feature. When you start your vehicle,
the lamps track left to right, then back to center to alert the driver that the
system is working properly.
Switching the Front Fog Lamps On or Off
Only switch the front fog lamps on during reduced visibility.
You can switch the front fog lamps on if any of the following occur:
You set the lighting co..
Switching the Direction Indicators On and Off
Push the lever up or down to switch the direction indicators on.
Note: Tap the lever up or down to make the direction indicators flash three
times...
Other information:
Use oil and fluid that meets the defined specification and viscosity grade.
If you do not use oil and fluid that meets the defined specification and viscosity
grade, it could result in:
Component damage not covered by the vehicle warranty.
Longer engine cranking periods...
Press the button to enter the settings
menu.
Once you select a tile, press the
button next to a menu item to view an explanation of the feature or setting.
Sound
Select this tile to adjust sound the settings.
Clock
Select this tile to adjust the clock settings...