Ford Explorer: Engine Ignition - 2.3L EcoBoost (201kW/273PS) / Removal and Installation - Spark Plugs
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the ignition coil-on-plugs.
Refer to: Ignition Coil-On-Plug (303-07A Engine Ignition - 2.3L EcoBoost (201kW/273PS), Removal and Installation).
-
Use compressed air to remove any foreign material in the spark plug well before removing the spark plugs.
-
NOTICE:
Do not remove the spark plugs when the engine is hot
or cold soaked. Spark plug thread or cylinder head damage can occur.
Make sure that the engine is warm (hand touch after cooling down) prior
to spark plug removal.
NOTICE:
If a spark plug is dropped, internal damage may
result and the spark plug must be discarded. The use of a damaged spark
plug may cause cylinder misfire resulting in engine damage.
Remove the spark plugs.
Torque:
106 lb.in (12 Nm)
Installation
-
To install, reverse the removal procedure.
Removal
NOTICE:
Do not pull the engine appearance cover forward or
sideways to remove. Failure to press straight upward on the underside of
the cover at the attachment points may result i..
Other information:
Removal
NOTE:
The rear heater core inlet line is installed from the
factory as a one-piece assembly. The replacement part is supplied as an
assembly, containing the rear heater core outlet line and the rear
evaporator inlet and outlet lines.
Remove the rear evaporator rear outlet and inlet line...
Special Tool(s) /
General Equipment
Air Conditioning Service Unit
Electronic Leak Detector
Air Conditioning Adaptor Kit
Leak detection
Recover the refrigerant. Refer to Air Conditioning (A/C)
System Recovery, Evacuation and Charging procedure in Group 412...
Categories
4 Inch Display

A - Tachometer.
B - Information display.
C - Speedometer.
D - Fuel gauge.
E - Engine coolant temperature gauge.
read more