Kia Picanto: Police Equipment / Removal and Installation - Siren Speaker
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the front bumper cover.
Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
-
Remove the siren speaker.
-
Disconnect the siren speaker electrical connector.
-
Remove the mounting bolts and the siren speaker.
Torque:
18 lb.ft (25 Nm)
Installation
-
To install, reverse the removal procedure.
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Release the wedge nut.
NOTE:
Typical application shown...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Detach the windshield washer hose coupling.
Detach the windshield washer hose pin-type retainers from the hood hinge.
On both sides...
Brake and Clutch Fluid (If Equipped). Checking the Brake and Clutch Fluid Level
Checking the Brake and Clutch Fluid Level
Figure 1. Petrol 1.0 MPI, 1.0 FFV and 1.2 MPI
Figure 2...
Categories
WARNING: Position the seatbelt height adjuster so that the seatbelt rests
across the middle of your shoulder. Failure to adjust the seatbelt correctly could
reduce its effectiveness and increase the risk of injury in a crash.

read more