Ford Explorer: Body Closures / Removal and Installation - Rear Door Check Arm
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH similar.
-
Open the door.
-
Remove the check arm bolt.
Torque:
18 lb.ft (25 Nm)
-
Remove the rear door trim panel.
Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Remove the front door speaker.
Refer to: Rear Door Speaker (415-00A Information and Entertainment System - General Information - Vehicles Without: SYNC 3, Removal and Installation).
-
Remove the door check arm cover.
-
Remove the nuts.
Torque:
80 lb.in (9 Nm)
-
Remove the check arm assembly.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Open the door...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
This step is only necessary when installing a new component...
Other information:
Removal
Remove the climate control housing.
Refer to: Climate Control Housing (412-00 Climate Control System - General Information, Removal and Installation).
Remove the screws and the air inlet door actuator.
Disconnect the electrical connector...
Special Tool(s) /
General Equipment
205-1016Installer, Differential BearingTKIT-2014D-ROW2TKIT-2014D-FL_ROW
205-153
(T80T-4000-W)
Handle
Two Leg Puller
DISASSEMBLY
Remove the differential carrier.
Refer to: Differential Carrier (205-02 Rear Drive Axle/Differential, Removal and Installation)...
Categories
Note: You may not be able to shift out of park (P) unless the intelligent
access key is inside your vehicle.

read more