Ford Explorer: Rear Disc Brake / Removal and Installation - Brake Caliper Anchor Plate
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the brake pads.
Refer to: Brake Pads (206-04 Rear Disc Brake, Removal and Installation).
-
Remove the bolts and the anchor plate. Discard the bolts
Torque:
122 lb.ft (165 Nm)
Installation
-
To install, reverse the removal procedure.
Removal
WARNING:
Service actions on vehicles equipped with electronic brake
booster and electronic parking brakes may cause unexpected brake
application, which could result in injury to ..
Materials
Name
Specification
Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B
-
Removal
WARNING:
Service actions on vehicles equipped with electronic brake
..
Other information:
Special Tool(s) /
General Equipment
303-1521Alignment Tool, Crankshaft Position SensorTKIT-2010C-FLM
303-1686Holding Tool, Camshaft
303-1689Holding Tool, Crank Damper
303-507Timing Peg, Crankshaft TDCTKIT-2001N-FLMTKIT-2001N-ROW
Materials
Name
Specification
Motorcraft® Silicone Brake Caliper Grease and Dielectric CompoundXG-3-A
ESE-M1C171-A
..
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
NOTE:
Repair individual door lock cylinders by discarding the
inoperative door lock cylinder and building a new door lock cylinder
using the appropriate lock repair service kit...
Categories
Push the lever up or down to operate
the windshield wipers.
A - Single wipe.
read more