Kia Picanto: Front End Body Panels / Removal and Installation - Active Grille Shutter Actuator

Ford Explorer 2020-2026 Service Manual / Body and Paint / Body and Paint / Front End Body Panels / Removal and Installation - Active Grille Shutter Actuator

Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. Remove the Radiator grille opening panel.
    Refer to: Radiator Grille Opening Panel (501-02 Front End Body Panels, Removal and Installation).

Upper active grille shutter actuator

  1. Remove the upper actuator spacer assembly.
  1. Disconnect the electrical connector and the bolt.
    Torque: 44 lb.in (5 Nm)

NOTE: The upper active grille shutter actuator is not interchangeable with the lower active grill shutter actuator. Do not attempt to replace one actuator with the other.

  1. Pull and remove the upper active grille shutter actuator.

Lower active grille shutter actuator

  1. Remove the lower actuator spacer assembly.
  1. Disconnect the electrical connector and the bolt.
    Torque: 44 lb.in (5 Nm)

NOTE: The lower active grille shutter actuator is not interchangeable with the upper active grill shutter actuator. Do not attempt to replace one actuator with the other.

  1. Pull and remove the lower active grille shutter actuator.

Installation

  1. To install, reverse the removal procedure.

    Diagnosis and Testing - Active Grille Shutter

    Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Informati..

    Removal and Installation - Cowl Panel

    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the wiper linkage assembly. Refer to: Wiper Linkage Assembly (501-16 Wipers and Washers, Removal a..

    Other information:

    Ford Explorer 2020-2026 Service Manual: General Procedures - Factory Mode Deactivation


    Deactivation NOTE: During vehicle build, some modules, such as the IPC and BCM module are set in factory mode. Factory mode reduces the drain on the battery during longer periods where the vehicle is not used. While in the factory mode, various systems may be altered or disabled and the IPC displays FACTORY MODE CONTACT DEALER in the message center...

    Ford Explorer 2020-2026 Owners Manual: Breaking-In & Reduced Engine Performance


    Breaking-In You need to break in new tires for approximately 300 mi (480 km). During this time, your vehicle may exhibit some unusual driving characteristics. Avoid driving too fast during the first 1,000 mi (1,600 km). Vary your speed frequently and change up through the gears early...

    Categories

    Integrated Keyhead Transmitter (If Equipped)

    Use the key blade to start your vehicle and unlock or lock the driver door from outside your vehicle. The integrated keyhead transmitter functions as a programmed ignition key that operates all the locks and starts your vehicle, as well as a remote control.

    read more

     
    Copyright © 2026 www.foexplorer.com