Ford Explorer: Lighting / Instrument Lighting Dimmer & Headlamp Exit Delay
Instrument Lighting Dimmer
The instrument lighting dimmer buttons are on the lighting control.
Repeatedly press one of the buttons
to adjust the brightness.

Headlamp Exit Delay
After you switch the ignition off, you can switch the headlamps on by pulling
the direction indicator lever toward you. You will hear a short tone. The headlamps
will switch off automatically after three minutes with any door open or 30 seconds
after the last door has been closed. You can cancel this feature by pulling the
direction indicator toward you again or switching the ignition on.
WARNING: The system does not relieve you of your responsibility to drive
with due care and attention. You may need to override the system if it does not
turn the headlamps on in low visibility con..
WARNING: The daytime running lamps system does not activate the rear lamps
and may not provide adequate lighting during low visibility driving conditions...
Other information:
Removal
Remove the front bumper cover.
Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
With the help of assistant.
Remove the bolts and the front bumper.
Torque:
35 lb.ft (48 Nm)
Installation
To install, reverse the removal procedure...
Special Tool(s) /
General Equipment
303-050
(T70P-6000)
Lifting Bracket, Engine
Adjustable Mounting Arm
Oil Drain Equipment
Side Cutter Pliers
Vehicle/Axle Stands
Cable Ties
Hose Clamp Remover/Installer
Powertrain Jack
Wooden Block
LHD AWD/LHD RWD
NOTI..
Categories
You can use the power door lock control or the remote control to lock and unlock
your vehicle.
Power Door Locks
The power door lock control is on the driver and front passenger door panels.

read more