Ford Explorer: Four-Wheel Drive Systems / General Procedures - Transfer Case Clutch Learn

Ford Explorer 2020-2026 Service Manual / Powertrain / Automatic Transmission / Four-Wheel Drive Systems / General Procedures - Transfer Case Clutch Learn

Activation

Update the AWD (all-wheel drive) module to the latest calibration available. Module reprogramming will erase stored transfer case clutch kiss point values and initiate rapid kiss point learn procedure. If no later calibration is available then proceed with process below:
- 1. Key OFF.
- 2. Open driver’s side door.
- 3. Close driver’s side door.
- 4. Wait 30 seconds.
- 5. Turn key on.
- 6. Wait 5 seconds.
- 7. Repeat steps 1-6 thirty five (35) times.

Diagnosis and Testing - DTC Chart and Pinpoint Tests

Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Informati..

Removal and Installation - All Terrain Control Module (ATCM)

Removal NOTE: Removal steps in this procedure may contain installation details. Selectable Drive Mode Switch - Shifter Button type Shifter Button type Refer to: Selector Lever Assemb..

Other information:

Ford Explorer 2020-2026 Service Manual: Removal and Installation - Windshield Wiper Motor

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the wiper linkage assembly. Refer to: Wiper Linkage Assembly (501-16 Wipers and Washers, Removal and Installation). NOTICE: Be careful not to damage the link seals during removal...

Ford Explorer 2020-2026 Service Manual: General Procedures - SYNC Module [APIM] Programming

Programming NOTE: If a new APIM is being installed, install the new APIM before carrying out the following procedure. If replacing the APIM do not connect the new APIM to a Wi-Fi network before completing scan tool APIM replacement programming as it may cause programming concerns...