Ford Explorer: Steering Column / General Procedures - Steering Wheel Cover Repair

Ford Explorer 2020-2026 Service Manual / Chassis / Steering System / Steering Column / General Procedures - Steering Wheel Cover Repair

Materials

Name Specification
Motorcraft® Instant Gel Adhesive
TA-19-C
WSS-M2G401-B5
 

Repair

  1. NOTE: If re-adhering leather to the front side of the steering wheel only, it will not be necessary to remove the steering wheel. Steering wheel removal is necessary only when repairing loose leather on the backside of the steering wheel.

    If necessary, remove the steering wheel.
    Refer to: Steering Wheel (211-04 Steering Column, Removal and Installation).
  1. Position the loose leather out of the way.
  1. NOTE: Avoid sanding the grooved area, if applicable.

    Sand steering wheel structure intended to be adhered.
  1. NOTE: Avoid applying adhesive in the grooved area, if applicable

    Apply the specified adhesive evenly over the wheel area to be adhered.
    Material: Motorcraft® Instant Gel Adhesive / TA-19-C (WSS-M2G401-B5)
  1. Position the loose leather back into the original position.
  1. NOTE: The adhesive should be completely set after 5 minutes. Do not pull on the repair area.

    Smooth the leather and tuck in for neat appearance.
  1. Apply pressure (for at least 30 seconds) until the leather is bonded to the wheel.
  1. If removed, install the steering wheel.
    Refer to: Steering Wheel (211-04 Steering Column, Removal and Installation).

    Diagnosis and Testing - Steering Column

    Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Informati..

    Removal and Installation - Steering Column

    Special Tool(s) / General Equipment Flat Headed Screw Driver Removal NOTICE: To prevent damage to the clockspring, make sure the front wheels are in the straight-ahead position...

    Other information:

    Ford Explorer 2020-2026 Service Manual: General Procedures - Paintwork Defects and Damage


    Materials Name Specification Motorcraft® Acid NeutralizerZC-1-A -  Motorcraft® Alkaline NeutralizerZC-2-A -  Repair NOTE: Refinishing - Environmental Damage   WARNING: Before beginning any service procedure in this manual, refer to health and safety warnings in section 100-00 General Information...

    Ford Explorer 2020-2026 Service Manual: General Procedures - Wire Terminal Inspection and Removal


    Disconnect   WARNING: Before beginning any service procedure in this section, refer to Health and Safety Precautions in section 100-00 General Information. Failure to follow this instruction may result in serious personal injury. Refer to: Health and Safety Precautions (100-00 General Information, Description and Operation)...

    Categories

    Locking and Unlocking

    You can use the power door lock control or the remote control to lock and unlock your vehicle.

    Power Door Locks

    The power door lock control is on the driver and front passenger door panels.

    read more

     
    Copyright © 2026 www.foexplorer.com