Ford Explorer: Reverse Braking Assist / Reverse Braking Assist Indicators & Troubleshooting

Ford Explorer 2020-2025 Owners Manual / Reverse Braking Assist / Reverse Braking Assist Indicators & Troubleshooting

Reverse Braking Assist Indicators

If the system determines that a collision with an obstacle may occur, full braking may automatically apply. Bring your vehicle to a stop a safe distance away from the obstacle.

A message and warning indicator appear when the system automatically applies the brakes.

Reverse Braking Assist – Troubleshooting

Reverse Braking Assist – Information Messages

The system has several preconditions for operation. If these preconditions are not met or if a fault occurs, a message appears when in reverse (R) letting you know that the system is off or unavailable. See Information Messages.

Reverse Braking Assist – Frequently Asked Questions

Note: If the frequently asked questions and answers that are shown in the following chart do not assist you in returning the system to available, contact an authorized dealer to have the system checked for proper operation.

Reverse Braking Assist Precautions

WARNING: You are responsible for controlling your vehicle at all times. The system is designed to be an aid and does not relieve you of your responsibility to drive with due care and attention...

Traction Control

Principle of Operation The traction control system helps avoid drive wheel spin and loss of traction. If your vehicle begins to slide, the system applies the brakes to individual wheels and, when ..

Other information:

Ford Explorer 2020-2025 Service Manual: Removal and Installation - Steering Column Lower Shaft

Removal NOTE: Removal steps in this procedure may contain installation details. NOTICE: Do not allow the steering column to rotate while the steering column shaft is disconnected or damage to the steering column internal sensor may result...

Ford Explorer 2020-2025 Service Manual: Removal and Installation - Wireless Accessory Charging Module (WACM)

Removal NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new module after installation. Using a diagnostic scan tool, begin the PMI process for the WACM following the on-screen instructions...