Ford Explorer: Rear Suspension / Removal and Installation - Spring

Ford Explorer 2020-2023 Service Manual / Chassis / Suspension / Rear Suspension / Removal and Installation - Spring

Removal

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

  1. Remove the lower arm.
    Refer to: Lower Arm (204-02 Rear Suspension, Removal and Installation).
  1. Remove the spring.

Installation

  1. Visual check.
    Check the upper spring seat for damage. Replace as necessary.
  1. Install the spring.
  1. NOTE: Make sure that the spring is correctly located in the upper spring seat.

    Visual check.
    Align the spring in the upper spring seat.
  1. Install the lower arm.
    Refer to: Lower Arm (204-02 Rear Suspension, Removal and Installation).

    Removal and Installation - Rear Stabilizer Bar Link

    Removal NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense...

    Removal and Installation - Toe Link

    Special Tool(s) / General Equipment Vehicle/Axle Stands Removal NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems...

    Other information:

    Ford Explorer 2020-2023 Owners Manual: Anti-Theft Alarm


    The system will warn you of an unauthorized entry to your vehicle. It will be triggered if any door, the luggage compartment or the hood is opened without using the key, remote control or keyless entry keypad. The direction indicators will flash and the horn will sound if unauthorized entry is attempted while the alarm is armed...

    Ford Explorer 2020-2023 Service Manual: General Procedures - Adaptive Learning Drive Cycle


    Programming NOTE: Perform the adaptive learning drive cycle on a level road surface. Using the scan tool, clear the DTCs (Diagnostic Trouble Codes) and Transmission Adaptive Tables. Drive the vehicle until the engine and transmission reach normal operating temperature...

    Categories

    Integrated Keyhead Transmitter (If Equipped)

    Use the key blade to start your vehicle and unlock or lock the driver door from outside your vehicle. The integrated keyhead transmitter functions as a programmed ignition key that operates all the locks and starts your vehicle, as well as a remote control.

    read more

     
    Copyright © 2023 www.foexplorer.com