Ford Explorer: Seatbelt Systems / General Procedures - Seatbelt Tongue Rotated On Belt
Adjustment
NOTE:
Typical seatbelt tongue shown, others similar.
-
Fold the seatbelt as indicated.
-
-
Feed the folded portion of the seatbelt into the seatbelt tongue.
-
Pull the seatbelt through the seatbelt tongue to remove the twist in the seatbelt.
Check
Functional Test - Seatbelt Buckle and Tongue
WARNING:
All seatbelt components must be inspected and corrected
as part of any collision repair...
Adjustment
NOTE:
Typical D-ring shown, others similar.
If required, remove the necessary trim panel(s).
Fold the seatbelt as indicated...
Other information:
System Operation
Gasoline Vehicles
The
main battery, which is located in the engine compartment, is a 12 volt
DC source connected in a negative ground system and is a voltage
stabilizer for the 12 volt electrical system.
A BMS
is attached to the negative side of the battery cable and a generator
current sensor (if equipped) is attached to the positive side of the
battery cable...
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
BCM
B130F:1..
Categories
WARNING: Position the seatbelt height adjuster so that the seatbelt rests
across the middle of your shoulder. Failure to adjust the seatbelt correctly could
reduce its effectiveness and increase the risk of injury in a crash.

read more