Ford Explorer: Security / Anti-Theft Alarm
The system will warn you of an unauthorized entry to your vehicle. It will be
triggered if any door, the luggage compartment or the hood is opened without using
the key, remote control or keyless entry keypad.
The direction indicators will flash and the horn will sound if unauthorized entry
is attempted while the alarm is armed.
IPTV Free Trial Take all remote controls to an authorized dealer if there is any potential alarm
problem with your vehicle.
Arming the Alarm
The alarm is ready to arm when there is not a key in your vehicle. Electronically
lock your vehicle to arm the alarm.
Disarming the Alarm
Disarm the alarm by any of the following actions:
- Unlock the doors or luggage compartment with the remote control or keyless
entry keypad.
- Switch your vehicle on or start your vehicle.
- Use a key in the driver door to unlock your vehicle, then switch your vehicle
on within 12 seconds.
Note: Pressing the panic button on the remote control will stop the horn
and signal indicators, but will not disarm the system.
Note: The system is not compatible with non-Ford aftermarket remote start
systems. Use of these systems may result in vehicle starting problems and a loss
of security protection...
Other information:
Removal
Raise the front seat to its highest point of travel.
Remove the front seat cushion blower motor.
Disconnect the electrical connector.
Rotate the blower motor 45 degrees clockwise.
Installation
To install, reverse the removal procedure...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the rear spoiler.
Refer to: Rear Spoiler (501-08 Exterior Trim and Ornamentation, Removal and Installation).
Remove the high mounted stop lamp...
Categories
Note: You may not be able to shift out of park (P) unless the intelligent
access key is inside your vehicle.

read more